Cisco 3524XL Hardware Installation Guide - Page 81
Step 1, Switch IP address
UPC - 746320224220
View all Cisco 3524XL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 2 Installing and Starting Up the Switch Assigning Switch Information You will need the following information from your system administrator: Switch IP address Subnet mask (netmask Default gateway (router Enable secret password Use this procedure to create an initial configuration for the switch: Note Be sure the rollover cable is connecting a PC serial port to the switch console port. The data characteristics are 9600 baud, 8 data bits, 1 stop bit, and no parity. Use the supplied rollover cable and DB-9 adapter to connect a PC to the switch console port. You need to provide a RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. You can order a kit (part number ACS-DSBUASYN=) containing that adapter from Cisco. For console port and adapter pinout information, see the "Cable and Adapter Specifications" section on page B-4. Step 1 Step 2 Step 3 Step 4 Enter Y at the prompt: Continue with configuration dialog? [yes/no]: y If this prompt does not appear, enter enable, and press Return. Enter setup, and press Return to restart the setup program. Enter the switch IP address, and press Return: Enter IP address: ip_address Enter the subnet mask (IP netmask) address, and press Return: Enter IP netmask: ip_netmask Enter Y to specify a default gateway (router): Would you like to enter a default gateway address? [yes]: y 78-6456-03 Catalyst 3500 Series XL Hardware Installation Guide 2-25