Cisco 3845 Message Guide - Page 20
AUTHMGR Messages - restart
UPC - 746320981420
View all Cisco 3845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
AUTHMGR Messages Chapter 2 Messages and Recovery Procedures Error Message ACLMGR-3-RELOADED: Reloading [chars] label [dec] feature. Explanation The ACL manager can now load more of the configured features on this label into the hardware. One or more features had previously been unloaded because of lack of space. [chars] is the direction (input or output), and [dec] is the label number. Recommended Action No action is required. Error Message ACLMGR-3-UNKNOWNACTION: Unknown VMR access group action [hex]. Explanation An internal software error has occurred. [hex] is an internal action code. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC, or provide your Cisco technical support representative with your information. For more information about these online tools and about contacting Cisco, see the "Error Message Traceback Reports" section on page 1-5. Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature. Explanation The ACL manager could not fit the complete configuration into the hardware, so some features will be applied in the software. Some or all of the packets in a VLAN are forwarded by the CPU. Multicast packets might be dropped entirely instead of being forwarded. [chars] is the direction (input or output), and [dec] is the label number. Recommended Action Use a simpler configuration. Use the same ACLs on multiple interfaces, if possible. AUTHMGR Messages Error Message AUTHMGR-5-SECURITY_VIOLATION: Security violation on the interface [chars], new MAC address ([enet) is seen. AuditSessionID [chars] Explanation A host on the interface attempted to access the network or attempted an authentication. The interface mode does not support the number of hosts that are attached to the interface. This is a security violation, and the interface has been error-disabled. The first [chars] is the interface, [enet] is the Ethernet address of the host, and the second [chars] is the session ID. Recommended Action Make sure that the interface is configured to support the number of hosts that are attached to it. Enter the shutdown interface configuration command followed by no shutdown interface configuration command to restart the interface. Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide 2-6 OL-23408-01