Cisco 3845 Message Guide - Page 25
channel-group, PAgP is enabled on the Layer 3 interface, but the partner port is not enabled for PAgP. - image
![]() |
UPC - 746320981420
View all Cisco 3845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2 Messages and Recovery Procedures EC Messages Error Message EC-5-ERRPROT: Channel protocol mismatch for interface [chars] in group [dec]: the interface can not be added to the channel group. Explanation The interface cannot be added to the channel group with the specified mode. [chars] is the interface, and [dec] is the channel group. Recommended Action Change the channel group or the mode for the interface. Error Message EC-5-ERRPROT2: Command rejected: the interface [chars] is already part of a channel with a different type of protocol enabled. Explanation The interface cannot be selected for the specified protocol because it is already part of a channel with a different protocol. [chars] is the interface. Recommended Action Remove the interface from the channel group. Error Message EC-5-ERRPROT3: Command rejected: the interface [chars] is already part of a channel. Explanation The interface cannot be unselected for the specified protocol because it is already part of a channel group. [chars] is the interface. Recommended Action Remove the interface from the channel group. Error Message EC-5-L3DONTBNDL1: [chars] suspended: PAgP not enabled on the remote port. Explanation PAgP is enabled on the Layer 3 interface, but the partner port is not enabled for PAgP. In this mode, the port is placed in a suspended state. [chars] is the Layer 3 interface. Recommended Action Enable PAgP on the remote side by using the channel-group interface configuration command. Error Message EC-5-L3DONTBNDL2: [chars] suspended: LACP currently not enabled on the remote port. Explanation LACP is enabled on a Layer 3 interface but is not enabled on the partner port. The port is put in a suspended state. [chars] is the interface name. Recommended Action Enable LACP on the remote side. Error Message EC-5-NOLACP: Invalid EC mode, LACP not enabled. Explanation The EtherChannel mode cannot be set because LACP is not included in the software image. Recommended Action Install a software image that includes LACP, and set the EC mode to on. OL-23408-01 Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide 2-11
![](/manual_guide/products/cisco-3845-message-guide-8b81c11/25.png)