Cisco 3845 Message Guide - Page 67

Chapter 2 Messages and Recovery Procedures QOSMGR Messages Error Message QOSMGR-3-INITIALIZING_INTERNAL_LINK_FAIL: Failed to initialize internal link [dec]. Explanation An internal software error has occurred. [dec] is the interface. Recommended Action Check if any other messages indicate resource failure. If other messages indicate that the hardware resources are exceeded, retry the command with a smaller configuration. Find out more about the error by using the show tech-support privileged EXEC command. Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC, or provide your Cisco technical support representative with your information. For more information about these online tools and about contacting Cisco, see the "Error Message Traceback Reports" section on page 1-5. Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed. Explanation The command to configure a QoS setting failed. This is possibly due to lack of hardware resources. [chars] is the description of the command. Recommended Action Look for any other messages that indicate resource failure. If other messages indicate that the hardware resources are exceeded, retry the command with a smaller configuration. Find out more about the error by using the show tech-support privileged EXEC command. Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC, or provide your Cisco technical support representative with your information. For more information about these online tools and about contacting Cisco, see the "Error Message Traceback Reports" section on page 1-5. Error Message QOSMGR-4-HARDWARE_PROGRAMMING_ERROR: Hardware programming error encountered for policymap [chars]. Explanation An internal software error has occurred. [chars] is the policy-map name. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC, or provide your Cisco technical support representative with your information. For more information about these online tools and about contacting Cisco, see the "Error Message Traceback Reports" section on page 1-5. Error Message QOSMGR-4-POLICER_PLATFORM_NOT_SUPPORTED: Policer configuration has exceeded hardware limitation for policymap [chars]. Explanation The policy-map configuration has exceeded the limitation of the hardware. An attempt to configure more policers in all policy maps (by using the police or police aggregate policy-map class configuration command) than supported by hardware, which is not allowed, causes this condition. [chars] is the policy-map name. Recommended Action Reconfigure the class maps or the policy maps, or delete the policy map from some interfaces. OL-23408-01 Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide 2-53