Cisco CSS11503-AC Hardware Installation Guide - Page 78
Cisco CSS11503-AC Manual
View all Cisco CSS11503-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Chapter 2 Connecting the Chassis to Ground Cabling and Troubleshooting the CSS Table 2-8 Tools and Supplies (continued) Quantity 1 Description Crimping tool Comments Must fit diameter of grounding lugs. Cisco Systems recommends that you use a crimping tool recommended by the lug manufacturer. 2 M5 screws with captive, locking Included in accessory kit washers shipped with the CSS. Attaching the Grounding Cable The following procedure describes how to attach: • • The grounding lug to the grounding cable The grounding cable to the chassis Warning When you install or replace the unit, the ground connection must always be made first and disconnected last. 1. 2. Power off the chassis by setting the power switch (or switches) to the O (off) position. Strip the covering from the end of the grounding wire (Figure 2-10). The amount of covering to be stripped varies depending on the type of lug you plan to attach to the wire. Strip Length 13/16 inch (2 cm) 1 1/16 inch (2.7 cm) 3/4 inch (1.9 cm) 7/8 inch (2.2 cm) Lug Panduit no. LCD6-10A-L (supplied in accessory kit) Panduit no. LCC6-10A-L (long barrel) Thomas & Betts no. 256-30695-1183(*4*) Burndy no. YA6CL2TC10 Cisco 11500 Series Content Services Switch Hardware Installation Guide 2-24 78-13884-06