Cisco CSS11503-AC Hardware Installation Guide - Page 84
Cisco CSS11503-AC Manual
View all Cisco CSS11503-AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Chapter 2 Connecting the Power Cord Cabling and Troubleshooting the CSS Warning When installing the wires, always connect the ground wire first. When disconnecting the wires, always disconnect the ground wire last. 5. Tighten the captive screws to 5 to 7 inch-pounds (0.6 to 0.8 Nm) of torque to secure the wires in the connectors. Ensure that the wires are held firmly in place. Install the wires to the DC power source. For the proper power cable wiring between the CSS 11503 and DC power source, see Table 2-9. 6. Table 2-9 CSS 11503 to DC Power Source Cabling CSS 11503 (Ground) + - DC Power Source (Ground) + - Warning The proper wiring sequence is ground to ground, positive to positive, and negative to negative. The ground wire should always be connected first and disconnected last. 7. 8. Switch on the circuit breaker that services the DC circuit. To check the DC power connection, see the "Checking the DC Power Connection (CSS 11503 and CSS 11506)"section. Connecting a CSS 11506 Power Cord The following sections provide information for connecting an AC or DC power cords to a CSS 11506. • • Connecting a CSS 11506 AC Power Cord Connecting a CSS 11506 DC Power Cord Cisco 11500 Series Content Services Switch Hardware Installation Guide 2-30 78-13884-06