Cisco SGE2000 Software Configuration Guide - Page 39

Configuring the Fabric Extender Verifying the Chassis Management Information cisco id is -cisco extended id number is 4 The following example shows how to display the status of the feature sets on the device: switch# show feature-set Feature Set Name ID fcoe 1 fabricpath 2 fex 3 switch# State -------- installed enabled enabled The following example shows how to display the services used by the Fabric Extender feature set: switch# show feature-set services fex vntag_mgr fex 2 services in feature set fex switch# Verifying the Chassis Management Information To display configuration information used on the switch supervisor to manage the Fabric Extender, perform one of the following commands: Command or Action Purpose show environment fex {all | FEX-number} [temperature | power | fan] Displays the environmental sensor status. show inventory fex FEX-number Displays inventory information for a Fabric Extender. show module fex [ FEX-number ] Displays module information about a Fabric Extender. show sprom fex FEX-number {all | backplane | powersupply ps-num} | all Displays the contents of the serial PROM (SPROM) on the Fabric Extender. Configuration Examples for Chassis Management This example shows how to display the module information about all connected Fabric Extender units: switch# show module fex FEX Mod Ports Card Type Model Status. 101 1 48 Fabric Extender 48x1GE + 4x10G M N2K-C2248TP-1GE ok FEX Mod Sw Hw World-Wide-Name(s) (WWN) 101 1 5.1(1) 3.5 -- FEX Mod MAC-Address(es) Serial-Num 101 1 5475.d0a9.4940 to 5475.d0a9.496f JAF1418AARL This example shows how to display the inventory information about a specific Fabric Extender: switch# show inventory fex 101 NAME: "FEX 101 CHASSIS", DESCR: "N2K-C2248TP-1GE CHASSIS" PID: N2K-C2248TP-1GE , VID: V00 , SN: SSI13380FSM OL-25816-02 Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide 29