Cisco VG224 Software Guide - Page 22
Using the setup Command, Configuring Global Parameters - rommon
UPC - 746320575360
View all Cisco VG224 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Using the setup Command Chapter 2 Using the setup Command Using the setup Command The setup command facility is displayed in your PC terminal emulation program window. To create a basic configuration for your Cisco VG224, do the following: • Complete the steps in "Configuring Global Parameters" section on page 2-2. • Complete the steps in "Configuring Controller and Interface Parameters" section on page 2-5. • Complete the steps in "Completing the Configuration" section on page 2-6. Note If you make a mistake while using the setup command facility, you can exit and run the facility again. Press Ctrl-C, and type setup at the enable mode prompt (Router#). Configuring Global Parameters Step 1 Power on the Cisco VG224. The power switch is on the rear panel of the Cisco VG224, at the lower-right corner, near the power cord. Messages begin to appear in your terminal emulation program window. Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are interpreted as the first command typed when the messages stop, which might cause the Cisco VG224 to power off and start over. It takes a few minutes for the messages to stop. The messages look similar to the following: Note Much of the following example is largely for a Cisco VG224. The messages vary, depending on the Cisco IOS software release, interface modules in place in your Cisco VG224, and feature set you select. In addition, the word "Router" is the default prompt, and may appear elsewhere; interpret this word as meaning "Cisco VG224." The screen displays in this section are for reference only and might not exactly reflect the messages on your console. System Bootstrap, Version 12.3(20030210:192652) [INT-mcebu_sb.wk.0.3.2 102], DEVELOPMENT SOFTWARE Copyright (c) 1986-2003 by cisco Systems, Inc. FPGA readonly version:0015001C FPGA upgrade version :001A001E Upgrade FPGA currently running cvg224 processor with 131072 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled Upgrade ROMMON initialized rommon 1 > dir slot0: program load complete, entry point:0x80008000, size:0xa0e0 Directory of slot0: 2 9711556 -rw- vg224-i6s-mz-swell_2.0.4.1 9486 10051540 -rw- vg224-i6s-mz.pi3_dhcp rommon 2 > b slot0:vg224-i6s-mz-swell_2.0.4.1 Cisco VG224 Voice Gateway Software Configuration Guide 2-2 OL-5005-01