Cisco VG224 Software Guide - Page 25

Chapter 2 Using the setup Command Configuring Controller and Interface Parameters Community string [public]: Configure LAT? [no]: Configure IP? [yes]: Configure IGRP routing? [yes]: Your IGRP autonomous system number [1]: 1 Note If you answer no to IGRP, you are prompted to configure RIP. Step 9 Configure bridging? [no]: (Optional) Configure CHAP: All users dialing in through the PRI will need to be authenticated using CHAP. The username and password are case sensitive. Do you want to enter username and passwords for PPP authentication ? [no]: Step 10 Configure the ISDN switch type for PRI. The following ISDN switch types are available: [0] none............If you do not want to configure ISDN [1] primary-4ess....AT&T 4ESS switch type for US and Canada [2] primary-5ess....AT&T 5ESS switch type for US and Canada [3] primary-dms100..Northern Telecom switch type for US and Canada [4] primary-net5....European switch type for NET5 [5] primary-ni......National ISDN Switch type for the U.S [6] primary-ntt.....Japan switch type [7] primary-qsig....QSIG switch type [8] primary-ts014...Australian switch type Choose ISDN PRI Switch Type [2]: Note BRI is not currently supported. Configuring Controller and Interface Parameters From this point on in the setup process, the prompts you see vary depending on the interface cards installed in your Cisco VG224. The following sections provide examples of the setup steps for card. Refer to the sections appropriate to your Cisco VG224. Configuration examples include the following: • Configuring Fast Ethernet and Serial Interface Parameters, page 2-5 • Configuring Fast Ethernet and Serial Interface Parameters, page 2-5 When you complete the setup steps for your interface modules, go to Completing the Configuration, page 2-6 for directions on saving your configuration. Configuring Fast Ethernet and Serial Interface Parameters This section illustrates the following: OL-5005-01 Cisco VG224 Voice Gateway Software Configuration Guide 2-5