Craftsman 28913 Operation Manual - Page 21
Large Retainer Spring
View all Craftsman 28913 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
_traSos dentro : use anteojos o cuando de seguseguridad ruptor de la ra que "STOP" rgue (muerta), ;, cuando el andando en notor caliente ponga "caf&" iempre pare ;n _.reas con e el tractor scrito antedposici6n del LA ;eleraciSn ocidad inferior miento dis- .me a la veloci- .ANTE Y HA- _ovimiento son Lnca de cambio. el pedal Ldoy con la :ici6n de neutro , a la posici6n le embrague/ _ovimiento. :tor pare cambios o de hace 1oande su transejeo _E CORTE DE antamiento del corte niento_ :o pulgar y n deseada. ; de aproximats alturas se de la cuchi!la ando. Estas en variar de_1suelo, de la :6sped que se WSEARRVNICINEG: ORTOADAJUVOSTIDMENSTESR:IOUS INJURY, BEFORE PERFORMING ANY 1, Depress clutch/brake pedal fully and set parking brake_ 2, Place gearshift lever in neutral (N) position, 3. Place attachment clutch in "DISENGAGED" positiono 4. Turn ignition key to "STOP" and remove key. i 5. Make sure the blades and al! moving parts have completely stopped. 6. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug, TRACTOR TO REMOVE MOWER Mower will be easier to remove from the right side of tractor. I_ Place attachment clutch in "DISEN- GAGED" position° 2, Move attachment lift lever fonNard to lower mower to its lowest position_ 3_ Roll belt off engine pulley. 4. Remove small retainer spring, and re- move clutch spring off pulley bolt. 5_ Remove large retainer spring, slide col- lar off and push housing guide out of bracket° 6, Disconnect anti-sway bar from chassis bracket by removing retainer spring, 7_ Disconnect suspension arms from rear deck brackets by removing retainer springs. 8. Disconnect front links from deck by removing retainer springs, 9. Raise lift lever to raise suspension arms. Slide mower out from under tractor_ IMP O RTANT: If an attachment other than the mower' deck is to be mounted on the tractor, remove the front links and hook the clutch spring Into square hole in frame. TO INSTALL MOWER 1. Raise attachment lift lever to its highest position, 2. Slide mower under tractor with deflector shield to right side of tractor. 3. Lower lift lever to its lowest position, 4. Connect front links to mower deck and secure with retainer springs,. 5_ Connect suspension arms to rear deck brackets and secure with retainer springs. 6. Connect antFsway barto chassis bracket and secure with retainer spring. 7. Push clutch cable housing guide into bracket, slide collar onto guide and secure with large retainer spring. 8. Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring. 9. Install belt onto engine pulley. Small Retainer S Clutch S_ Small Retainer Spring Clutch Spring Retainer Spring--._ Anti-Sway Bar Co Housing Guide Bracket Large Retainer Spring 2I Front Link Retainer Springs Both Sides) Deflector Shield