Craftsman 28913 Operation Manual - Page 23
nelproducto
View all Craftsman 28913 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
)n elproducto, ÷ VANTAMtENTO LA SEGADORA DAL DE FRENO I )E EMBRAGUE GRO$ DE !DIENTES s de seguddad) , evita, 4no se evita, ires. no se evita, deradas. _imbolo de aviso, _r daSos al eligro que. re, tesiones Mla, puede o/o danos TO REPLACE MOWER BLADE DRIVE BELT The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL - 1. Remove mower from tractor (See "TO REMOVE MOWER" in this section of manual). 2, Work belt off both mandrel pulleys and idler pulleys° 3. Pull belt away from mower, BEt_T INSTALLATION - I, Work belt around both mandrel pulleys and idler pulleys 2. Make sure belt is in all pulley grooves and inside all belt guides. 3. install mower (See "To Install Mower" in this section of this manual)_ Mandrel Idler Pulleys Mandrel Pulley TO REPLACE MOTION DRIVE BELT Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL- 1, Remove mower (See "TO REMOVE MOWER" in this section of manual)° NOTE: Observe entire motion drive belt and position of all belt guides and keepers. 2o Remove belt from stationary idler and clutching idler. 3. Remove belt downward from around engine pulley_ 4_ Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keepers. 5. Remove belt from center span keeper and pull belt away from tractor, BELT INSTALLATION - 1o Carefully work new belt down between transaxle belt keepers and onto the input pulley. 2. Slide belt into the .center span keeper. 3. Pull belt toward front of tractor and roll around the top groove of engine pulley 4, Install belt through stationary idler and clutching idler. 5. Make sure belt is in all pulley grooves and inside all belt guides and keepers. 6o install mower (See "TO INSTALL MOW- ER" in this section of manual)_ Engine TO CHECK BRAKE If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced, You may also check brake by: 1. Park tractor on a level, dry concrete or paved surface, depress clutch!brake pedal all the way down and engage parking brake. 2. Place gear shift lever in neutral position. The rear wheels must lock and skid when you try to manually push the tractor fowvard. If the rear wheels rotate, then the brake needs to be serviced° Contact a Sears or other qualified service center° Clutching Stationary Idler Transaxle Pulle, Center Keeper 23