Craftsman 28913 Operation Manual - Page 25
fueradela
View all Craftsman 28913 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
_ctofrueradela ;truccionespara ao npezar, leer, eniones presentes ._este manual. .m un &rea bien )na delante del las y objetos. rOTOR FUERA SECCION DE 3ALIDAD Y LA _S) :amiento det acta. _miento presio_=/freno. sen la posici6n telante fuera de Irucciones TO REMOVE CABLES, REVERSE ORDER - t_ BLACK cable first from chassis and then from the fully charged battery. 2. RED cable last from both batteries. !'.__ !' ,, Weak or Dead Fully Charged Battery Battery REPLACING BATTERY _WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc_ Positive terminal must be connected first to prevent sparking from accidental grounding_ Io Lift seat pan to raised position° 2. Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor. 3. Install new batterywith terminals in same position as old battery, 4. First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal 5. Connect BLACK grounding cable to negative (4) terminal with remaining hex bolt and keps nut. Tighten securely. 3. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. 4. Close hood. INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting° - Check wiring. See electrical wiring dia- gram in the Repair Parts section. TO REPLACE FUSE Replace with 20 amp automotive-type plugin fuse. The fuse holder is located behind the dash. TO REMOVE HOOD AND GRILL ASSEMBLY 1. Raise hoo& 2. Unsnap headlight wire connector, 3. Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor, 4. When replacing hood, be sure to reconnect the headlight wire connector. ( \, Hood Headlight Wire Connector Seat Label ENGINE Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any non-road engine repair establishment or individual. Warranty repairs Terminal Keps /Nut must be performed by an aLrthorized engine manufacturer's service outleL Cover " - ._- Hex tf-.".#_::;*=_tt- Bolt / TO ADJUST THROTTLE CONTROL CABLE The throttle control has been preset at the Positiv factory and adjustment should not be neces- (Red) _i_'_1_" sary Check adjustment as described below Cable Negative (Black) Cable before loosening cable. If adjustment is TO REPLACE HEADLIGHT BULB necessary, proceed as follows: 1. With engine not running, move throttle 1. Raise hood. control lever from slow to choke position. 2. Pull bulb holder out of the hole in the Slowly move lever from choke to fast backside of the grill. 25 position_