Creative CT4180 Getting Started Guide - Page 31
To enable or disable MPU401 emulation in DOS/Windo..., In AWE Control Panel, click the Device button. - jumper
View all Creative CT4180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
To enable or disable MPU401 emulation in DOS/Windows 3.1x 1. If your audio card is already installed, switch off your computer and all peripheral devices. Remove the the cover from your system and then the audio card. 2. Enable or disable the MFBEN jumper according to the settings shown in Figure B-1. Enabled (Factory default setting) Disabled Figure B-1: Available MPU-401 MIDI Emulation settings. To enable or disable MPU401 emulation in Windows 95 1. Start AWE Control Panel. 2. In AWE Control Panel, click the Device button. 3. In the Device Selection dialog box, make sure that the Allow MPU401 Emulation On This Device check box is selected, and then click the Select button. 4. In AWE Control Panel, click the Quit button. B-4 Changing Audio Card Settings