Dell Dimension 9100 Owner's Manual - Page 115
Clearing CMOS Settings
View all Dell Dimension 9100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
2 Locate the 3-pin password jumper (PSWD) on the system board (see page 63), and attach the jumper plug to pins 2 and 3 to clear the password. NOTE: When you receive your computer, the jumper plug is attached to pins 1 and 2. 3 Close the computer cover (see page 102). 4 Connect your computer and monitor to electrical outlets, and turn them on. 5 After the Microsoft® Windows® desktop appears on your computer, shut down the computer (see page 55). 6 Turn off the monitor and disconnect it from the electrical outlet. 7 Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system board. 8 Open the computer cover (see page 60). 9 Locate the 3-pin password jumper (PSWD) on the system board (see page 63) and attach the jumper to pins 1 and 2 to reenable the password feature. 10 Close the computer cover (see page 102). NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer. 11 Connect your computer and devices to electrical outlets, and turn them on. Clearing CMOS Settings CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. 1 Follow the procedures in "Before You Begin" on page 55. 2 Reset the current CMOS settings: a Locate the 3-pin CMOS jumper (RTCRST) on the system board (see page 63). b Remove the jumper plug from pins 2 and 3. c Place the jumper plug on pins 1 and 2 and wait approximately five seconds. d Replace the jumper plug on pins 2 and 3. 3 Close the computer cover (see page 102). NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 4 Connect your computer and devices to electrical outlets, and turn them on. Appendix 115