Dell Force10 S4820T Installing the S4820T System - Page 30

Plug in the appropriate cord AC 3 prong or DC wiring from the switch PSU to the external power

Get Dell Force10 S4820T PDF manuals and user guides View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

www.dell.com | support.dell.com 1 Remove the PSU slot cover from the S4820T (PSU side of switch), either of the two PSU slots may be selected. 2 Remove the PSU from the electrostatic bag. 3 Insert the PSU into the switch PSU slot (PSU exposed PCB edge connector should be inserted first). The PSU slot is keyed such that the PSU can only be fully inserted in one orientation. When the PSU is installed correctly it should snap into place and be flush with the back of the switch. 4 Plug in the appropriate cord (AC 3 prong or DC wiring) from the switch PSU to the external power source (either AC wall outlet or DC rack bus bar). 5 If you have a redundant PSU (2nd PSU), repeat steps 1 through 5 above using the 2nd PSU slot on the S4820T switch. NOTE: The system powers up as soon as the cables are connected between the power supply and the power source. 30 | Installing the S4820T

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
30
|
Installing the S4820T
www.dell.com | support.dell.com
1
Remove the PSU slot cover from the S4820T (PSU side of switch), either of the two PSU slots may
be selected.
2
Remove the PSU from the electrostatic bag.
3
Insert the PSU into the switch PSU slot (PSU exposed PCB edge connector should be inserted first).
The PSU slot is keyed such that the PSU can only be fully inserted in one orientation. When the PSU
is installed correctly it should snap into place and be flush with the back of the switch.
4
Plug in the appropriate cord (AC 3 prong or DC wiring) from the switch PSU to the external power
source (either AC wall outlet or DC rack bus bar).
5
If you have a redundant PSU (2nd PSU), repeat steps 1 through 5 above using the 2nd PSU slot on
the S4820T switch.
NOTE:
The system powers up as soon as the cables are connected between the power supply and the power
source.