Dell Force10 S4820T Installing the S4820T System - Page 41
Connecting a DC Power Supply to the Power Source
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
To replace an AC or DC power supply, follow these steps: Step Task 1 Disconnect the power cable from the PSU. 2 Loosen the securing screws on the PSU with a screwdriver. Ensure that the PSU loose and can be easily removed. 3 Use the grab handle to slide the PSU out of the power supply bay. 4 Use the grab handle on the replacement PSU to slide the PSU into the power supply bay. 5 Tighten the securing screws on the replacement PSU with a screwdriver. Ensure that the PSU is secure. 6 Attach the power cord to the replacement PSU. WARNING: The S4820T powers up as soon as the cables are connected between the power supply and the power source. Connecting a DC Power Supply to the Power Source Each DC powered S4820T comes with a set containing a pre-wired (3-inch 8AWG) power supply connector and a four-screw wiring block. One set is provided for each DC PSU (See Figure 5-2). Figure 5-2. DC Power Connector and Wiring Block Screws Wiring Block Power Connector Power Supplies | 41