Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 127

Figure 7-21. Command Example: show config in the ROUTE-MAP Mode Force10(config-route-map)#show config ! route-map dilling permit 10 Force10(config-route-map)# You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a configured route map is applied to a command, like redistribute, traffic passes through all instances of that route map until a match is found. Figure 7-22 shows an example with two instances of a route map. Figure 7-22. Command Example: show route-map with Multiple Instances of a Route Map Force10#show route-map route-map zakho, permit, sequence 10 Match clauses: Set clauses: route-map zakho, permit, sequence 20 Match clauses: interface GigabitEthernet 0/1 Set clauses: tag 35 level stub-area Force10# Route map zakho has two instances To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence number to the command syntax (Figure 246). Figure 7-23. Deleting One Instance of a Route Map Force10(conf)#no route-map zakho 10 Force10(conf)#end Force10#show route-map route-map zakho, permit, sequence 20 Match clauses: interface GigabitEthernet 0/1 Set clauses: tag 35 level stub-area Force10# Figure 7-24 shows an example of a route map with multiple instances. The show config command displays only the configuration of the current route map instance. To view all instances of a specific route map, use the show route-map command. Access Control Lists (ACL), Prefix Lists, and Route-maps | 127