Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 290

www.dell.com | support.dell.com Command Syntax ip address ip-address mask [secondary] Command Mode INTERFACE Purpose Configure a primary IP address and mask on the interface. The ip-address must be in dotted-decimal format (A.B.C.D) and the mask must be in slash format (/xx). Add the keyword secondary if the IP address is the interface's backup IP address. You can only configure one (1) primary IP address per interface. You can configure up to 255 secondary IP addresses on a single interface. To view all interfaces to see with an IP address assigned, use the show ip interfaces brief command in the EXEC mode (Figure 176). To view IP information on an interface in Layer 3 mode, use the show ip interface command in the EXEC Privilege mode (Figure 159). Figure 15-7. Command Example: show ip interface Force10>show ip int vlan 58 Vlan 58 is up, line protocol is up Internet address is 1.1.49.1/24 Broadcast address is 1.1.49.255 Address determined by config file MTU is 1554 bytes Inbound access list is not set Proxy ARP is enabled Split Horizon is enabled Poison Reverse is disabled ICMP redirects are not sent ICMP unreachables are not sent Management Interfaces The S55 system supports the Management Ethernet interface as well as the standard S-Series interface on any port. Either method can be used to connect to the system. Configure Management Interfaces on the E-Series and C-Series and on the S55 On the E-Series, C-Series, and S55 the dedicated Management interface provides management access to the system. You can configure this interface with FTOS, but the configuration options on this interface are limited. Gateway addresses and IP addresses cannot be configured if it appears in the main routing table of FTOS. In addition, Proxy ARP is not supported on this interface. Note: On the S55, a default IP address is assigned to the Management port. Use this IP address to set your laptop Ethernet port to the same network for test purposes. 290 | Interfaces