Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 300

www.dell.com | support.dell.com Figure 15-13. Command Example from Reassigning an Interface to a Different Port Channel Force10(conf-if-portch)#show config ! interface Port-channel 4 no ip address channel-member GigabitEthernet 1/8 no shutdown Force10(conf-if-portch)#no chann gi 1/8 Force10(conf-if-portch)#int port 5 Force10(conf-if-portch)#channel gi 1/8 Force10(conf-if-portch)#sho conf ! interface Port-channel 5 no ip address channel-member GigabitEthernet 1/8 shutdown Force10(conf-if-portch)# Configure the minimum oper up links in a port channel (LAG) You can configure the minimum links in a port channel (LAG) that must be in "oper up" status for the port channel to be considered to be in "oper up" status. Use the following command in the INTERFACE mode: Command Syntax minimum-links number Command Mode INTERFACE Purpose Enter the number of links in a LAG that must be in "oper up" status. Default: 1 Figure 15-14 displays an example of configuring five minimum "oper up" links in a port channel. Figure 15-14. Example of using the minimum-links Command Force10#config t Force10(conf)#int po 1 Force10(conf-if-po-1)#minimum-links 5 Force10(conf-if-po-1)# Add or remove a port channel from a VLAN As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a VLAN, you must place the port channel in Layer 2 mode (by using the switchport command). 300 | Interfaces