Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 702

www.dell.com | support.dell.com • Enabling PortFast on page 709 • Preventing Network Disruptions with BPDU Guard on page 711 • STP Root Selection on page 713 • SNMP Traps for Root Elections and Topology Changes on page 713 • Configuring Spanning Trees as Hitless on page 713 Important Points to Remember • Spanning Tree Protocol (STP) is disabled by default. • FTOS supports only one Spanning Tree instance (0). For multiple instances, you must enable MSTP, or PVST+. You may only enable one flavor of Spanning Tree at any one time. • All ports in VLANs and all enabled interfaces in Layer 2 mode are automatically added to the Spanning Tree topology at the time you enable the protocol. • To add interfaces to the Spanning Tree topology after STP is enabled, enable the port and configure it for Layer 2 using the command switchport. • The IEEE Standard 802.1D allows eight bits for port ID and eight bits for priority. However, the eight bits for port ID provide port IDs for only 256 ports and the C-Series can contain 336 ports. To accommodate the increased number of ports, FTOS uses four bits from priority field in the port ID field.This implementation affects the Bridge MIB (RFC 1493), and you must interpret objects such as dot1dStpPortDesignatedPort object by using the first four bits as the priority and the last 12 bits as the port ID. 702 | Spanning Tree Protocol