Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 308

www.dell.com | support.dell.com Exclude a smaller port range If interface range has multiple port ranges, the smaller port range is excluded from prompt: Figure 15-20. Interface Range Prompt Excluding a Smaller Port Range Force10(conf)#interface range gigabitethernet 2/0 - 23 , gigab 2/1 - 10 Force10(conf-if-range-gi-2/0-23)# Overlap port ranges If overlapping port ranges are specified, the port range is extended to the smallest start port number and largest end port number: Figure 15-21. Interface Range Prompt Including Overlapping Port Ranges Force10(conf)#inte ra gi 2/1 - 11 , gi 2/1 - 23 Force10(conf-if-range-gi-2/1-23)# Commas The example below shows how to use commas to add different interface types to the range, enabling all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2. Force10(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2 Force10(config-if-range-gi-5/1-23)# no shutdown Force10(config-if-range-gi-5/1-23)# Figure 15-22. Multiple-Range Bulk Configuration Gigabit Ethernet and Ten-Gigabit Ethernet Add ranges The example below shows how to use commas to add VLAN and port-channel interfaces to the range. Figure 15-23. Multiple-Range Bulk Configuration with VLAN, and Port-channel Force10(config-ifrange-gi-5/1-23-te-1/1-2)# interface range Vlan 2 - 100 , Port 1 - 25 Force10(config-if-range-gi-5/1-23-te-1/1-2-so-5/1-vl-2-100-po-1-25)# no shutdown Force10(config-if-range)# 308 | Interfaces