Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 59

Enable FTP server To enable the system as an FTP server, use the following command in the CONFIGURATION mode: Command Syntax ftp-server enable Command Mode Purpose CONFIGURATION Enable FTP on the system. To view FTP configuration, use the show running-config ftp command (Figure 41) in the EXEC privilege mode. Figure 4-4. show running-config ftp Command Output Force10#show running ftp ! ftp-server enable ftp-server username nairobi password 0 zanzibar Force10# Configure FTP server parameters After the FTP server is enabled on the system, you can configure different parameters. To configure FTP server parameters, use any or all of the following commands in the CONFIGURATION mode: Command Syntax ftp-server topdir dir ftp-server username username password [encryption-type] password Command Mode Purpose CONFIGURATION Specify the directory for users using FTP to reach the system. The default is the internal flash directory. CONFIGURATION Specify a user name for all FTP users and configure either a plain text or encrypted password. Configure the following optional and required parameters: • username: Enter a text string • encryption-type: Enter 0 for plain text or 7 for encrypted text. • password: Enter a text string. Note: You cannot use the change directory (cd) command until ftp-server topdir has been configured. To view the FTP configuration, use the show running-config ftp command in EXEC privilege mode. Management | 59