Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 687

Table 38-3. MIB Objects for Copying Configuration Files via SNMP MIB Object OID copyDestFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.6 copyDestFileName .1.3.6.1.4.1.6027.3.5.1.1.1.7 copyServerAddress .1.3.6.1.4.1.6027.3.5.1.1.1.8 copyUserName .1.3.6.1.4.1.6027.3.5.1.1.1.9 copyUserPassword .1.3.6.1.4.1.6027.3.5.1.1.1.10 Object Values Description 1 = flash 2 = slot0 3 = tftp 4 = ftp 5 = scp Specifies the location of destination file. • If the copyDestFileLocation is FTP or SCP, copyServerAddress, copyUserName, and copyUserPassword must be specified. Path (if file is not in Specifies the name of destination file. default directory) and filename. IP Address of the server The IP address of the server. • If the copyServerAddress is specified so must copyUserName, and copyUserPassword. Username for the server. Username for for the FTP, TFTP, or SCP server. • If the copyUserName is specified so must copyUserPassword. Password for the server. Password for the FTP, TFTP, or SCP server. To copy a configuration file: Step 1 2 3 Task Command Syntax Command Mode Create an SNMP community string with read/ snmp-server community write privileges. community-name rw CONFIGURATION Copy the f10-copy-config.mib MIB from the Dell Force10 iSupport webpage to the server to which you are copying the configuration file. On the server, use the command snmpset as shown: snmpset -v snmp-version -c community-name -m mib_path/f10-copy-config.mib force10system-ip-address mib-object.index {i | a | s} object-value... • Every specified object must have an object value, which must be preceded by the keyword i. See Table 6 for valid values. • index must be unique to all previously executed snmpset commands. If an index value has been used previously, a message like the one in Message 3 appears. In this case, increment the index value and enter the command again. • Use as many MIB Objects in the command as required by the MIB Object descriptions in Table 6 to complete the command. See Table 7 or examples. Note: You can use the entire OID rather than the object name. Use the form: OID.index i object-value, as shown in Figure 57. Message 2 snmpset Index Value Error Error in packet. Reason: notWritable (that object does not support modification) Failed object: FORCE10-COPY-CONFIG-MIB::copySrcFileType.101 Simple Network Management Protocol | 687