Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 324

www.dell.com | support.dell.com Figure 15-34. show Commands with configured Keyword Examples Force10#show interfaces configured Force10#show interfaces linecard 0 configured Force10#show interfaces gigabitEthernet 0 configured Force10#show ip interface configured Force10#show ip interface linecard 1 configured Force10#show ip interface gigabitEthernet 1 configured Force10#show ip interface br configured Force10#show ip interface br linecard 1 configured Force10#show ip interface br gigabitEthernet 1 configured Force10#show running-config interfaces configured Force10#show running-config interface gigabitEthernet 1 configured In EXEC mode, the show interfaces switchport command displays only interfaces in Layer 2 mode and their relevant configuration information. The show interfaces switchport command (Figure 15-35) displays the interface, whether the interface supports IEEE 802.1Q tagging or not, and the VLANs to which the interface belongs. Figure 15-35. show interfaces switchport Command Example Force10#show interfaces switchport Name: GigabitEthernet 13/0 802.1QTagged: True Vlan membership: Vlan 2 Name: GigabitEthernet 13/1 802.1QTagged: True Vlan membership: Vlan 2 Name: GigabitEthernet 13/2 802.1QTagged: True Vlan membership: Configure Interface Sampling Size Use the rate-interval command, in INTERFACE mode, to configure the number of seconds of traffic statistics to display in the show interfaces output. Although any value between 30 and 299 seconds (the default) can be entered, software polling is done once every 15 seconds. So, for example, if you enter "19", you will actually get a sample of the past 15 seconds. All LAG members inherit the rate interval configuration from the LAG. Figure 15-36 shows how to configure rate interval when changing the default value: 324 | Interfaces