Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 50

www.dell.com | support.dell.com Figure 4-1. Create a Custom Privilege Level Force10(conf)#do show run priv ! privilege exec level 3 capture privilege exec level 3 configure privilege exec level 4 resequence privilege exec level 3 capture bgp-pdu privilege exec level 3 capture bgp-pdu max-buffer-size privilege configure level 3 line privilege configure level 3 interface Force10(conf)#do telnet 10.11.80.201 [telnet output omitted] Force10#show priv Current privilege level is 3. Force10#? capture Capture packet configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC ip Global IP subcommands monitor Monitoring feature mtrace Trace reverse multicast path from destination to source ping Send echo messages quit Exit from the EXEC show Show running system information [output omitted] Force10#config [output omitted] Force10(conf)#do show priv Current privilege level is 3. Force10(conf)#? end Exit from configuration mode exit Exit from configuration mode interface Select an interface to configure line Configure a terminal line linecard Set line card type Force10(conf)#interface ? fastethernet Fast Ethernet interface gigabitethernet Gigabit Ethernet interface loopback Loopback interface managementethernet Management Ethernet interface null Null interface port-channel Port-channel interface range Configure interface range sonet SONET interface tengigabitethernet TenGigabit Ethernet interface vlan VLAN interface Force10(conf)#interface gigabitethernet 1/1 Force10(conf-if-gi-1/1)#? end Exit from configuration mode exit Exit from interface configuration mode Force10(conf-if-gi-1/1)#exit Force10(conf)#line ? aux Auxiliary line console Primary terminal line vty Virtual terminal Force10(conf)#line vty 0 Force10(config-line-vty)#? exit Exit from line configuration mode Force10(config-line-vty)# 50 | Management