Dell Force10 S55T S55 Configuration Guide FTOS 8.3.5.3 - Page 790

www.dell.com | support.dell.com Auto Save on Crash or Rollover Exception information on for master or standby units is stored in the flash:/TRACE_LOG_DIR directory. This directory contains files that save trace information when there has been a task crash or timeout. On a master unit, the TRACE_LOG_DIR files can be reached by FTP or by using the show file command from the flash://TRACE_LOG_DIR directory. On a Standby unit, the TRACE_LOG_DIR files can be reached only by using the show file command from the flash://TRACE_LOG_DIR directory. Note: Non-management member units do not support this functionality. Last restart reason (S55) If an S55 system restarted for some reason (automatically or manually), the show system command output includes the reason for the restart. The following table shows the reasons displayed in the output and their corresponding causes. Table 46-1. Line card restart causes and reasons Causes Displayed Reasons Remote power cycle of the chassis reload reboot after a crash push button reset soft reset soft reset show hardware commands (S55) Note: The show hardware command tree is supported on the S55 only. The show hardware command tree consists of EXEC Privilege commands used with the S55 system. These commands display information from a hardware sub-component and from hardware-based feature tables. Table 46-2 lists the show hardware commands available as of the latest FTOS version on the S55. Note: The show hardware commands should only be used under the guidance of Dell Force10 Technical Assistance Center. 790 | S-Series Debugging and Diagnostics