Dell Inspiron 16 Plus 7640 Owners Manual - Page 61
I/O board, Removing the I/O board
![]() |
View all Dell Inspiron 16 Plus 7640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
2. Align and place the palm-rest and keyboard assembly under the display hinges. 3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the palm-rest and keyboard assembly. 4. Replace the three screws (M2.5x5) that secure the left-display assembly hinge to the palm-rest and keyboard assembly. 5. Close the right-display assembly hinge and align the screw holes on the right-display assembly hinge with the screw holes on the palm-rest and keyboard assembly. 6. Replace the three screws (M2.5x5) that secure the right-display assembly hinge to the palm-rest and keyboard assembly. 7. Connect the display-assembly cable to its connector on the system board and close the latch. 8. Adhere the tape to secure the display-cable latch to its connector to the system board. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. I/O board Removing the I/O board CAUTION: The information in this section is intended for authorized service technicians only. Prerequisites 1. Follow the procedure in Before working inside your computer. NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your computer. 2. Remove the base cover. 3. Remove the fan. About this task The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure. Removing and installing Field Replaceable Units (FRUs) 61
![](/manual_guide/products/dell-inspiron-16-plus-7640-owners-manual-dd971bf/61.png)