Dell Inspiron 560s Service Manual - Page 28

Back to Contents Page Memory Module(s) Dell™ Inspiron™ 560s Service Manual Removing the Memory Module(s) Replacing the Memory Module(s) Recommended Memory Configuration Setting Up Dual-Channel Memory Configuration WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover. WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.) removed. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. Removing the Memory Module(s) 1. Follow the procedures in Before You Begin. 2. Remove the computer cover (see Removing the Computer Cover). 3. Locate the memory module(s) on the system board (see System Board Components). 4. Press out the securing clip at each end of the memory-module connector. 1 memory-module connector 2 securing clips (2) 5. Grasp the memory module and pull it upwards. If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the memory-module connector. Replacing the Memory Module(s) 1. Follow the procedures in Before You Begin. 2. Press out the securing clip at each end of the memory-module connector. 3. Follow the memory installation guidelines (see Recommended Memory Configuration). CAUTION: Do not install ECC memory modules. 4. Align the notch on the bottom of the memory module with the tab in the memory-module connector.