Dell OptiPlex 5080 Tower Service Manual - Page 25

Installing the 3.5-inch hard-disk drive, About this task, Steps, Prerequisites

Get Dell OptiPlex 5080 Tower PDF manuals and user guides View all Dell OptiPlex 5080 Tower manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

2. Remove the side cover. 3. Remove the fan duct. About this task The following images indicate the location of the 3.5-inch hard-disk drive and provides a visual representation of the removal procedure. Steps 1. Disconnect the data and power cables from the connectors on the 3.5-inch hard-disk drive module. 2. Slide the 3.5-inch. hard-disk drive up to release the four (#6-32) grommet screws from its slot on the chassis. 3. Remove the 3.5-inch hard-disk drive away from the chassis. Installing the 3.5-inch hard-disk drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the 3.5-inch hard-disk drive and provides a visual representation of the installation procedure. Disassembly and reassembly 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
2.
Remove the
side cover
.
3.
Remove the
fan duct
.
About this task
The following images indicate the location of the 3.5-inch hard-disk drive and provides a visual representation of the removal
procedure.
Steps
1.
Disconnect the data and power cables from the connectors on the 3.5-inch hard-disk drive module.
2.
Slide the 3.5-inch. hard-disk drive up to release the four (#6-32) grommet screws from its slot on the chassis.
3.
Remove the 3.5-inch hard-disk drive away from the chassis.
Installing the 3.5-inch hard-disk drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard-disk drive and provides a visual representation of the installation
procedure.
Disassembly and reassembly
25