Dell OptiPlex 5080 Tower Service Manual - Page 63
Steps, Next steps, Replace the two M3X3 screws to secure the optional I/O module to the system.
![]() |
View all Dell OptiPlex 5080 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Steps 1. To remove the dummy metal bracket, insert a flathead screwdriver in the hole of the bracket, push the bracket to release the bracket, and then lift the bracket out from the system. 2. Insert the optional I/O module (Type-C/HDMI/VGA/DP/Serial) into its slot from the inside of your computer. 3. Connect the I/O cable to the connector on the system board . 4. Replace the two (M3X3) screws to secure the optional I/O module to the system. Next steps 1. Install the fan duct. 2. Install the front bezel. 3. Install the side cover. 4. Follow the procedure in after working inside your computer. Disassembly and reassembly 63
![](/manual_guide/products/dell-optiplex-5080-tower-service-manual-8c51e62/63.png)
Steps
1.
To remove the dummy metal bracket, insert a flathead screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2.
Insert the optional I/O module (Type-C/HDMI/VGA/DP/Serial) into its slot from the inside of your computer.
3.
Connect the I/O cable to the connector on the system board .
4.
Replace the two (M3X3) screws to secure the optional I/O module to the system.
Next steps
1.
Install the
fan duct
.
2.
Install the
front bezel
.
3.
Install the
side cover
.
4.
Follow the procedure in
after working inside your computer
.
Disassembly and reassembly
63