Dell OptiPlex 5080 Tower Service Manual - Page 41
Installing the powered GPU, Coin-cell battery, Removing the coin-cell battery
![]() |
View all Dell OptiPlex 5080 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
2. Remove the side cover. 3. Remove the fan duct. About this task The following images indicate the location of the powered graphical processing unit and provides a visual representation of the removal procedure. Steps 1. Disconnect the two power cables from the connectors on the powered GPU. 2. Lift the pull tab to open the PCIe door. 3. Push and hold the securing tab on the graphics-card slot and lift the powered GPU away from the graphics-card slot. Installing the powered GPU Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the powered graphical processing unit and provides a visual representation of the installation procedure. Steps 1. Align the powered GPU with the PCI-Express card connector on the system board. 2. Using the alignment post, connect the powered GPU in the connector and press down firmly. Ensure that the powered GPU is firmly seated. 3. Lift the pull tab to close the PCIe door. 4. Connect the two power cables to the connector on the powered GPU. Next steps 1. Install the fan duct. 2. Install the side cover. 3. Follow the procedure in after working inside your computer. Coin-cell battery Removing the coin-cell battery Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the fan duct. 4. Remove the powered GPU. NOTE: This step is required only if the system is configured with powered GPU. About this task The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure. Disassembly and reassembly 41
![](/manual_guide/products/dell-optiplex-5080-tower-service-manual-8c51e62/41.png)