Dell PowerApp 110 Rack Installation Guide - Page 21

Before You Begin Before you begin installing your PowerApp appliance in the rack, carefully read "Safety Instructions", found earlier in this guide. NOTICE: This rack kit is intended to be installed in a Dell rack by trained service technicians. If you install the kit in any other rack, be sure that the rack meets the specifications of American National Standards Institute (ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-D-92, International Electrotechnical Commission (IEC) 297, and Deutsche Industrie Norm (DIN) 41494. One rack kit is required for each Dell server, storage system, or appliance that is installed in a rack. Recommended Tools and Supplies You need the following tools and supplies to install the appliance in a four-post rack cabinet: • A #2 Phillips screwdriver • A flat-blade screwdriver • Masking tape or a felt-tip pen, for use in marking the mounting holes to be used Installing the Rack Kit NOTES: If you purchased a Dell rack along with your PowerApp appliance, the slide assemblies may be preinstalled in the rack. For instructions on installing the PowerApp appliance itself, see "Installing the Appliance in the Rack" found later in this guide. To install the slide assemblies in the rack, perform the following steps: 1. Remove the rack's front and back doors. 2. Install the slide assemblies in the rack. The subsections that follow include instructions for performing these tasks. support.dell.com Rack Installation Guide 1-13