Dell PowerConnect 8024 CLI Reference Guide - Page 1109

Keyword uucp whois www Description Unix-to-Unix Copy Program Nickname World Wide Web Port Number 540 43 80 Example Following is an example of using the telnet command to connect to 176.213.10.50. console#telnet 176.213.10.50 Esc U sends telnet EL traceroute Use the traceroute command in Privileged EXEC mode to discover the IP routes that packets actually take when traveling to their destinations. You can use traceroute command in either of two formats: • You can specify the IP address and hostname in the command. The traceroute {ipaddress|hostname} command sets the parameters to their default values. • You can enter traceroute to without specifying the IP address and hostname, and specify values for the traceroute parameters. Syntax traceroute [ ip | ipv6 ] ipaddress | hostname [ initTtl initTtl ] [ maxTtl maxTtl ] [ maxFail maxFail ] [ interval interval ] [ count count ] [ port port ] [ size size ] • ipaddress - Valid IP address of the destination host. • hostname - Hostname of the destination host (Range: 1-158 characters). • initTtl - The initial time-to-live (TTL); the maximum number of router hops between the local and remote system (Range: 0-255). • maxTtl - The largest TTL value that can be used (Range:1-255). • maxFail - Terminate the traceroute after failing to receive a response for this number of consecutive probes (Range: 0-255). • interval - The time between probes in seconds (Range: 1-60 seconds). • count - The number of probes to be sent at each TTL level (Range:1-10). • port - The destination UDP port of the probe. This should be an unused port on the remote destination system (Range: 1-65535). • size - The size, in bytes, of the payload of the Echo Requests sent (Range: 0-65507 bytes). System Management Commands 1109