Dell PowerConnect 8024 CLI Reference Guide - Page 798

Example The following example sets a route preference value of 100 for intra OSPF in the router. console(config)#ipv6 router ospf console(config-rtr)#distance ospf intra 100 enable Use the enable command in Router OSPFv3 Configuration mode to enable administrative mode of OSPF in the router (active). Syntax enable no enable Default Configuration Enabled is the default state. Command Mode Router OSPFv3 Configuration mode. User Guidelines This command has no user guidelines. Example The following example enables administrative mode of OSPF in the router (active). console(config)#ipv6 router ospf console(config-rtr)#enable exit-overflow-interval Use the exit-overflow-interval command in Router OSPFv3 Configuration mode to configure the exit overflow interval for OSPF. It describes the number of seconds after entering Overflow state that a router will wait before attempting to leave the Overflow State. This allows the router to originate non-default AS-external-LSAs again. When set to 0, the router will not leave Overflow State until restarted. Syntax exit-overflow-interval seconds 798 OSPFv3 Commands