Dell PowerConnect 8024 CLI Reference Guide - Page 125

Command Mode Port Channel VLAN Tunnel Loopback Access Method Command Prompt Exit or Access Previous Mode From Global Configuration mode, use the interface portchannel command. console (config-if- To exit to Global chn)# Configuration mode, use the exit command, or + to Privileged EXEC mode. From Global Configuration mode, use the interface vlan command. console(config-ifvlann)# To exit to Global Configuration mode, use the exit command, or press + to Privileged EXEC mode. From Global console(config- Configuration mode, tunneln)# use the interface tunnel command. To exit to Global Configuration mode, use the exit command, or press + to Privileged EXEC mode. From Global console(config- configuration mode, use loopbackn)# the interface loopback command. To exit to Global Configuration mode, use the exit command, or press + to Privileged EXEC mode. Starting the CLI To begin running the CLI, perform the following steps: N O T E : This procedure is for use on the console line only. N O T E : The Easy Setup Wizard is available only when the system is in default state with no user configuration saved previously. 1. Start the switch and wait until the startup procedure is complete and the User EXEC mode is entered. The prompt console> is displayed. 2. Configure the switch using the Easy Setup Wizard and enter the necessary commands to complete the required tasks. 3. When finished, exit the session with the quit or exit command. Using the CLI 125