Dell PowerConnect 8024 CLI Reference Guide - Page 618

console(config)#interface vlan 15 console(config-if-vlan15)#ip mtu 1480 ip netdirbcast Use the ip netdirbcast command in Interface Configuration mode to enable the forwarding of network-directed broadcasts. When enabled, network directed broadcasts are forwarded. When disabled they are dropped. Use the no form of the command to disable the broadcasts. Syntax ip netdirbcast no ip netdirbcast Default Configuration Disabled is the default configuration. Command Mode Interface Configuration (VLAN) mode User Guidelines This command has no user guidelines. Example The following example defines the IP address and subnet mask for VLAN 15. console(config)#interface vlan 15 console(config-if-vlan15)#ip netdirbcast ip route Use the ip route command in Global Configuration mode to configure a static route. Use the no form of the command to delete the static route. The IP route command sets a value for the route preference. Among routes to the same destination, the route with the lowest preference value is the route entered into the forwarding database. Specifying the preference of a static route controls whether a static route is more or less preferred than routes from dynamic routing protocols. The preference also controls whether a static route is more or less preferred than other static routes to the same destination. Syntax ip route ip addr {subnetmask | prefix length } nextHopRtr [ preference ] 618 IP Routing Commands