Dell PowerEdge M610x Fabric OS Message Reference - Page 116
AUTH-1004, Probable Cause
View all Dell PowerEdge M610x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
4 AUTH-1004 AUTH-1004 Message , [AUTH-1004], ,, ERROR, , Failed to set type to . Probable Cause Indicates that the authUtil command has failed to set the authentication configuration value. The data type is either authentication type, DH group type, or policy type. Recommended Action Retry the authUtil command. Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1005 Message , [AUTH-1005], ,, ERROR, , Authentication file does not exist: . Probable Cause Indicates an authentication file corruption. Recommended Action Run the firmwareDownload command to reinstall the firmware. Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1006 Message , [AUTH-1006], ,, WARNING, , Failed to open authentication configuration file. Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING AUTH-1007 Message Probable Cause , [AUTH-1007], ,, ERROR, , The proposed authentication protocols are not supported: port . Indicates that the proposed authentication protocol type or types are not supported by the local specified port. 40 Fabric OS Message Reference 53-1001767-01