Dell PowerEdge M610x Fabric OS Message Reference - Page 443
HAMK System Messages, HAMK-1001
View all Dell PowerEdge M610x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 443 highlights
Chapter HAMK System Messages 44 HAMK-1001 Message , [HAMK-1001], , SLOT cp-slot-number | CHASSIS, FFDC, CRITICAL, , Warm recovery failed. Probable Cause Indicates the switch failed during the warm recovery. Recommended Action This message triggers a switch reboot automatically and attempts a cold recovery. Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity CRITICAL HAMK-1002 Message , [HAMK-1002], , SLOT cp-slot-number | CHASSIS, INFO, , Heartbeat down. Probable Cause Indicates that the active control processor (CP) blade determined that the standby CP blade is down. This can be a result of an operator-initiated action such as the firmwareDownload command, the standby CP blade being reset or removed, of an error in the standby CP blade. Recommended Action Monitor the standby CP blade for a few minutes. If this message is due to a standby CP reboot, the message HAMK-1003 will display after the standby CP has completed the reboot successfully. If the standby CP does not successfully connect to the active CP after 10 minutes, reboot the standby CP blade by ejecting the blade and reseating it. Severity INFO HAMK-1003 Message , [HAMK-1003], , SLOT cp-slot-number | CHASSIS, INFO, , Heartbeat up. Probable Cause Indicates that the active control processor (CP) blade detects the standby CP blade. This message indicates that the standby CP blade is available to take over in case a failure happens on the active CP blade. Recommended No action is required. This message means that the standby CP is healthy. Action Severity INFO Fabric OS Message Reference 367 53-1001767-01