Dell PowerEdge M610x Fabric OS Message Reference - Page 535
PDM System Messages, PDM-1001
View all Dell PowerEdge M610x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 535 highlights
Chapter PDM System Messages 75 PDM-1001 Message , [PDM-1001], ,, WARNING, , Failed to parse the pdm config. Probable Cause Indicates the parity data manager (PDM) process could not parse the configuration file. This might be caused by a missing configuration file during the installation. Recommended Action Run the firmwareDownload command to reinstall the firmware. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING PDM-1002 Message , [PDM-1002], ,, WARNING, , ipcInit failed. Probable Cause Indicates the parity data manager (PDM) process could not initialize the inter-process communication (IPC) mechanism. Recommended If the message persists, run the supportFtp command (as needed) to set up automatic FTP Action transfers; then run the supportSave command and contact your switch service provider. Severity WARNING PDM-1003 Message , [PDM-1003], ,, WARNING, , pdm [-d] -S -s . Probable Cause Indicates a syntax error occurred when trying to launch the parity data manager (PDM) process. Recommended Action Run the firmwareDownload command to reinstall the firmware. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING Fabric OS Message Reference 459 53-1001767-01