Dell PowerEdge VRTX Chassis Management Controller Version 1.0 for Dell PowerEd - Page 130
Configuring Linux for Server Serial Console Redirection After Boot
View all Dell PowerEdge VRTX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Edit the /etc/grub.conf file as follows: 1. Locate the general setting sections in the file and type the following two new lines: serial --unit=1 --speed=57600 terminal --timeout=10 serial 2. Append two options to the kernel line: kernel console=ttyS1,57600 3. If the /etc/grub.conf contains a splashimage directive, comment it out. The following example shows the changes described in this procedure. # grub.conf generated by anaconda # # Note that you do not have to rerun grub after making changes # to this file # NOTICE: You do not have a /boot partition. This means that # all kernel and initrd paths are relative to /, e.g. # root (hd0,0) # kernel /boot/vmlinuz-version ro root= /dev/sdal # initrd /boot/initrd-version.img # #boot=/dev/sda default=0 timeout=10 #splashimage=(hd0,2)/grub/splash.xpm.gz serial --unit=1 --speed=57600 terminal --timeout=10 serial title Red Hat Linux Advanced Server (2.4.9-e.3smp) root (hd0,0) kernel /boot/vmlinuz-2.4.9-e.3smp ro root= /dev/sda1 hda=ide-scsi console=ttyS0 console= ttyS1,57600 initrd /boot/initrd-2.4.9-e.3smp.img title Red Hat Linux Advanced Server-up (2.4.9-e.3) root (hd0,00) kernel /boot/vmlinuz-2.4.9-e.3 ro root=/dev/sda1 initrd /boot/initrd-2.4.9-e.3.img When you edit the /etc/grub.conf file, follow these guidelines: - Disable GRUB's graphical interface and use the text-based interface. Else, the GRUB screen is not displayed in console redirection. To disable the graphical interface, comment out the line starting with splashimage. - To start multiple GRUB options to start console sessions through the serial connection, add the following line to all options: console=ttyS1,57600 The example shows console=ttyS1,57600 added to only the first option. Configuring Linux for Server Serial Console Redirection After Boot Edit the /etc/inittab file as follows: Add a new line to configure agetty on the COM2 serial port: co:2345:respawn:/sbin/agetty -h -L 57600 ttyS1 ansi 130