Dell PowerEdge VRTX Chassis Management Controller Version 1.0 for Dell PowerEd - Page 81
Starting iDRAC IPv4 Address Slot 1, Enable iDRAC IPMI over LAN
View all Dell PowerEdge VRTX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Setting Enable iDRAC IPMI over LAN Enable iDRAC IPv4 DHCP Starting iDRAC IPv4 Address (Slot 1) iDRAC IPv4 Netmask iDRAC IPv4 Gateway Enable iDRAC IPv6 Enable iDRAC IPv6 Autoconfiguration iDRAC IPv6 Gateway iDRAC IPv6 Prefix Length Description Enables or disables the IPMI over LAN channel for each iDRAC present in the chassis. By default, this option is selected. Enables or disables DHCP for each iDRAC present in the chassis. If this option is enabled, the fields QuickDeploy IP, QuickDeploy Subnet Mask, and QuickDeploy Gateway are disabled, and cannot be modified since DHCP is used to automatically assign these settings for each iDRAC. To select this option, you must select the Enable iDRAC IPv4 option. Specifies the static IP address of iDRAC in the server, in slot 1 of the enclosure. The IP address of each subsequent iDRAC is incremented by 1 for each slot from slot 1's static IP address. In the case where the IP address plus the slot number is greater than the subnet mask, an error message is displayed. NOTE: The subnet mask and the gateway are not incremented such as the IP address. For example, if the starting IP address is 192.168.0.250 and the subnet mask is 255.255.0.0 then the QuickDeploy IP address for slot 15 is 192.168.0.265. If the subnet mask is 255.255.255.0, the QuickDeploy IP address range is not fully within QuickDeploy Subnet error message is displayed when you click Save QuickDeploy Settings or AutoPopulate Using QuickDeploy Settings. Specifies the QuickDeploy subnet mask that is assigned to all newly inserted servers. Specifies the QuickDeploy default gateway that is assigned to all the DRAC present in the chassis. Enables IPv6 addressing for each iDRAC present in the chassis that is IPv6 capable. Enables the iDRAC to obtain IPv6 settings (address and prefix length) from a DHCPv6 server and also enables stateless address auto configuration. By default, this option is enabled. Specifies the default IPv6 gateway to be assigned to the iDRACs. The default value is "::". Specifies the prefix length to be assigned for the IPv6 addresses on the iDRAC. The default value is 64. 3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click Apply iDRAC Network Settings to deploy the settings to the iDRAC. The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If Set iDRAC Root Password on Server Insertion and QuickDeploy Enabled are enabled, the user is prompted using the LCD interface 81