Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 100

• half - Specify to set the physical interface to transmit in only one direction. • auto - Specify to set the physical interface to transmit automatically. Defaults Command Mode Usage Information Example Not configured CONFIGURATION This command can only be used on the Management port. The no version of this command resets the value to the default. OS10(conf-if-ma-1/1/1)# duplex auto Supported Releases 10.3.0E or later enable auto-breakout Enables front-panel Ethernet ports to automatically detect SFP pluggable media and autoconfigure breakout interfaces. Syntax enable auto-breakout Parameters None Default Not configured Command mode CONFIGURATION Usage information After you enter the enable auto-breakout command and plug a supported breakout cable in a QSFP+ or QSFP28 port, the port autoconfigures breakout interfaces for media type and speed. The no version of this command disables the auto-breakout feature. The media type plugged into a port is no longer automatically learned. Use the interface breakout command to manually configure breakout interfaces. Example OS10(config)# enable auto-breakout Supported releases 10.4.0E(R1) or later fec Configures Forward Error Correction on 25G, 50G, and 100G interfaces. Syntax fec {CL74-FC | CL91-RS | CL108-RS | off} Parameters • CL74-FC - Supports 25G and 50G • CL91-RS - Supports 100G • CL108-RS - Supports 25G and 50G • off - Disables FEC Defaults • For 25G and 50G interfaces: off • For 100G interfaces: CL91-RS Command Mode CONFIGURATION 100 Interfaces