Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 75
Management interface, VLAN interfaces
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Pluggable media present, QSFP-PLUS type is QSFPPLUS_4X16_16GBASE_FC_SW Wavelength is 850 Receive power reading is 0.0 FC MTU 2188 bytes LineSpeed 8G Port type is F, Max BB credit is 1 WWN is 20:78:14:18:77:20:8d:cf Last clearing of "show interface" counters: 00:02:32 Input statistics: 33 frames, 3508 bytes 0 class 2 good frames, 33 class 3 good frames 0 frame too long, 0 frame truncated, 0 CRC 1 link fail, 0 sync loss 0 primitive seq err, 0 LIP count 0 BB credit 0, 0 BB credit 0 packet drops Output statistics: 33 frames, 2344 bytes 0 class 2 frames, 33 class 3 frames 0 BB credit 0, 0 oversize frames 6356027325 total errors Rate Info: Input 116 bytes/sec, 1 frames/sec, 0% of line rate Output 78 bytes/sec, 1 frames/sec, 0% of line rate Time since last interface status change: 00:00:24 Management interface The Management interface provides management access to the network device. You can configure the Management interface, but the configuration options on this interface are limited. You cannot configure gateway addresses and IP addresses if it appears in the main routing table, and proxy ARP is not supported on this interface. 1 Configure the Management interface in CONFIGURATION mode. interface mgmt 1/1/1 2 Configure an IP address and mask on the Management interface in INTERFACE mode. ip address A.B.C.D/prefix-length 3 Enable the Management interface in INTERFACE mode. no shutdown Configure management interface OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24 OS10(conf-if-ma-1/1/1)# no shutdown VLAN interfaces VLANs are logical interfaces and are, by default, in L2 mode. Physical interfaces and port-channels can be members of VLANs. OS10 supports inter-VLAN routing. You can add IP addresses to VLANs and use them in routing protocols in the same manner that physical interfaces are used. You cannot assign an IP address to VLAN1 (default). When using VLANs in a routing protocol, you must configure the no shutdown command to enable the VLAN for routing traffic. In VLANs, the shutdown command prevents L3 traffic from passing through the interface - L2 traffic is unaffected by this command. • Configure an IP address in A.B.C.D/x format on the interface in INTERFACE mode. The secondary IP address is the interface's backup IP address - you can configure up to eight secondary IP addresses. ip address ip-address/mask [secondary] Interfaces 75