Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 518
permit (IPv6
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 518 highlights
• A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - count - (Optional) Count packets the filter processes. - byte - (Optional) Count bytes the filter processes. - dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Usage Information Example Not configured IPV4-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter. OS10(config)# ip access-list testflow OS10(conf-ipv4-acl)# permit udp any any capture session 1 Supported Releases 10.2.0E or later permit (IPv6) Configures a filter to allow packets with a specific IPv6 address. Syntax permit [protocol-number | icmp | ipv6 | tcp | udp] [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | count [byte] | dscp value | fragment] Parameters • protocol-number - (Optional) Enter the protocol number identified in the IPv6 header, from 0 to 255. • icmp - (Optional) Enter the ICMP address to permit. • ipv6 - (Optional) Enter the IPv6 address to permit. • tcp - (Optional) Enter the TCP address to permit. • udp - (Optional) Enter the UDP address to permit. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - count - (Optional) Count packets the filter processes. - byte - (Optional) Count bytes the filter processes. - dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Not configured IPV6-ACL 518 Access Control Lists