Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 353
Summary address, Graceful restart, OSPFv2 authentication, View default route
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 353 highlights
View default route configuration OS10(config-router-ospf-10)# show configuration ! router ospf 10 default-information originate always Summary address You can configure a summary address for an ASBR to advertise one external route as an aggregate, for all redistributed routes that are covered by specified address range. • Configure the summary address in ROUTER-OSPF mode. summary-address ip-address/mask [not-advertise | tag tag-value] Configure summary address OS10(config)# router ospf 100 OS10(config-router-ospf-100)# summary-address 10.0.0.0/8 not-advertise View summary address OS10(config-router-ospf-100)# show configuration ! router ospf 100 summary-address 10.0.0.0/8 not-advertise Graceful restart When a networking device restarts, the adjacent neighbors and peers detect the condition. During a graceful restart, the restarting device and the neighbors continue to forward the packets without interrupting the network performance. The neighbors that help in the restart process are called as helper routers. When graceful restart is enabled, the restarting device retains the routes learned by OSPF in the forwarding table. To re establish OSPF adjacencies with neighbors, the restarting OSPF process sends a grace LSA to all neighbors. In response, the helper router enters helper mode and sends an acknowledgement back to the restarting device. OS10 supports graceful restart helper mode. Use the graceful-restart role helper-only command to enable the helper mode in the ROUTER OSPF mode. OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# graceful-restart role helper-only Use the no version of the command to disable the helper mode. OSPFv2 authentication You can enable OSPF authentication either with clear text or with MD5. • Set a clear text authentication scheme on the interface in INTERFACE mode. ip ospf authentication-key key • Set MD5 authentication in INTERFACE mode. ip ospf message-digest-key keyid md5 key Configure text authentication OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ip ospf authentication-key sample Layer 3 353