Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 396

Command Mode Example EXEC OS10# show ipv6 ospf interface ethernet1/1/1 is up, line protocol is up Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5 Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2 Network Type broadcast, Cost: 1 Transmit Delay is 1 sec, State BDR, Priority 1 Designated Router on this network is 2.2.2.2 Backup Designated router on this network is 10.0.0.2 (local) Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 2.2.2.2(Designated Router) Supported Releases 10.3.0E or later show ipv6 ospf neighbor Displays a list of OSPFv3 neighbors connected to the local router. Syntax Parameters Default Command Mode Usage Information show ipv6 ospf neighbor None Not configured EXEC • Neighbor ID-Displays the neighbor router ID. • Pri-Displays the priority assigned neighbor. • State-Displays the OSPF state of the neighbor. • Dead Time-Displays the expected time until the system declares the neighbor dead. • Interface ID-Displays the neighbor interface ID • Interface-Displays the interface type, node/slot/port or number information. Example OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor Neighbor ID Pri State Dead Time Interface ID Interface 2.2.2.2 1 Full/DR 00:00:30 5 ethernet1/1/1 Supported Releases 10.3.0E or later show ipv6 ospf statistics Displays OSPFv3 traffic statistics. Syntax Parameters show ipv6 ospf [instance-number] statistics [interface interface] • instance-number - (Optional) Enter an OSPFv3 instance number (1 to 65535). • interface interface - (Optional) Enter the interface information: - ethernet node/slot/port[:subport] - Enter an Ethernet port interface. - port-channel number - Enter the port-channel interface number (1 to 128). - vlan vlan-id - Enter the VLAN ID number (1 to 4094). Default Not configured 396 Layer 3