Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 26

Remote access You can remotely access the OS10 command-line interface (CLI) and the Linux shell. When you install OS10 the first time, connect to the switch using the serial port. Configure remote access • Configure the Management port IP address • Configure a default route to the Management port • Configure a user name and password Remote access OS10 CLI 1 Open an SSH session using the IP address of the device. You can also use PuTTY or a similar tool to access the device remotely. ssh admin@ip-address password: admin 2 Enter admin for both the default user name and password to log into OS10. You are automatically placed in EXEC mode. OS10# Remote access Linux shell ssh linuxadmin@ip-address password: linuxadmin Configure Management IP address To remotely access OS10, assign an IP address to the Management port. 1 Configure the management interface from CONFIGURATION mode. interface mgmt node/slot/port 2 Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode. ip address A.B.C.D/mask ipv6 address A:B/prefix-length 3 Enable the Management interface in INTERFACE mode. no shutdown Configure Management interface OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24 OS10(conf-if-ma-1/1/1)# no shutdown Management Route Configuration WARNING: Avoid configuring an IPv4 or IPv6 address and a static route for the management interface that conflict with an IPv4 or IPv6 address and static route on a front-end port interface. To set up remote access to OS10, configure a management route after you assign an IPv4 or IPv6 address to the Management port. The default management route is the path used by a Management port to communicate with a different network. Management routes are separate from IPv4 and IPv6 routes and are only used to manage the system through the Management port. management route 192.168.100.0/24 1.1.1.1 ip route 192.168.100.0/24 2.2.2.2 26 Getting Started