Dell PowerSwitch S4112F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 312
Con static routing
View all Dell PowerSwitch S4112F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 312 highlights
Wavelength is 64 SFP receive power reading is 0.0 Interface index is 16866084 Internet address is not set Mode of IPv4 Address Assignment: not set MTU 1532 bytes LineSpeed 40G, Auto-Negotiation on Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 60 Last clearing of "show interface" counters: 3 weeks 1 day 23:12:50 Queuing strategy: fifo Input statistics: 0 packets, 0 octets 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output statistics: 0 packets, 0 octets 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 Collisions, 0 wreddrops Rate Info(interval 299 seconds): Input 0 Mbits/sec, 0 packets/sec, 0% of line rate Output 0 Mbits/sec, 0 packets/sec, 0% of line rate Time since last interface status change: 3 weeks 1 day 20:54:37 Configure static routing You can configure a manual or static route for OSPF. • Configure a static route in CONFIGURATION mode. ip route ip-prefix/mask {next-hop | interface interface [route-preference]} - ip-prefix-IPv4 address in dotted decimal format-A.B.C.D. - mask-Mask in slash prefix-length format (/X). - next-hop-Next-hop IP address in dotted decimal format-A.B.C.D. - interface-Interface type with the node/slot/port information - route-preference-(Optional) Route-preference range-1 to 255. Configure static routes OS10(config)# ip route 200.200.200.0/24 10.1.1.2 View configured static routes OS10# show ip route static Codes: C - connected S - static B - BGP, IN - internal BGP, EX - external BGP O - OSPF,IA - OSPF inter area, N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2, E1 - OSPF external type 1, E2 - OSPF external type 2, > - non-active route Gateway of last resort is not set Destination Gateway Dist/Metric Last Change S 200.200.200.0/24 via 10.1.1.2 ethernet1/1/1 0/0 00:00:03 OS10 installs a static route if the next hop is on a directly connected subnet. A next-hop that is not on the directly connected subnet which recursively resolves to a next-hop on the interface's configured subnet is also automatically configured. For example, if interface 312 Layer 3