Dell PowerVault NX300 Hardware Owner's Manual - Page 129
System Battery, Replacing the System Battery
View all Dell PowerVault NX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
b Open the grease applicator included with your processor kit and apply all of the thermal grease in the applicator to the center of the topside of the new processor. c Place the heat sink on the processor. See Figure 3-20. d Replace the screws at the corners of the heat sink. See Figure 3-20. 12 Replace the cooling shroud. See "Installing the System Board Shroud" on page 103. 13 Close the system. See "Closing the System" on page 83. 14 Reconnect your system and peripherals to their electrical outlets, and turn on the system. 15 Press to enter the System Setup program, and check that the processor information matches the new system configuration. See "Entering the System Setup Program" on page 58. 16 Run the system diagnostics to verify that the new processor operates correctly. 17 See "Running the System Diagnostics" on page 167 for information about running the diagnostics. System Battery Replacing the System Battery WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. See your safety information for additional info. CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 82. Installing System Components 129