Dell PowerVault NX300 Hardware Owner's Manual - Page 143
Integrated Storage Controller Card on See
View all Dell PowerVault NX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
5 Install the new system board: a Holding the system board by the edges of the system board, lower the the system board into the chassis. CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components. b Slightly lift up the front of the system board and maneuver the system board to the bottom of the chassis until it lays completely flat. c Push the system board toward the back of the chassis until the board is in place. d Tighten the nine screws that secure the system board to the chassis. See Figure 3-30. e Tighten the processor heat sink screws. See "Installing a Processor" on page 126. 6 Connect the cables in the order listed below (see Figure 6-1 for the locations of the connectors on the system board): • SATA interface cable, if applicable • Control panel interface cable connector • Optical drive power cable connector • Control panel USB interface cable connector • SAS backplane power cable connector • System board power cable connectors 7 Replace the expansion-card risers. See "Replacing an Expansion-Card Riser" on page 100. 8 Install all expansion cards. See "Installing an Expansion Card" on page 93. 9 Reinstall the integrated storage controller card. See "Installing the Integrated Storage Controller Card" on page 97. After connecting the SAS cables to the controller, make sure to place the cables under the guide on the end of riser 1. 10 If applicable, reconnect the RAID battery cable to the PERC controller card. 11 If applicable, reinstall the iDRAC6 Enterprise card. See "Installing an iDRAC6 Enterprise Card" on page 105. Installing System Components 143